> -----Original Message-----
> From: Kamil Dudka [mailto:kdudka_at_redhat.com]
> Sent: Monday, October 19, 2009 2:36 PM
> To: Xu, Qiang (FXSGSC)
> Cc: curl-library_at_cool.haxx.se
> Subject: Re: libcurl and libssh2
> You want to tweak your MANPATH. Look at /etc/man.conf and
> man.conf(5) man page. Or you can configure curl build with
> --enable-manual and then you'll have the manual available via
> curl --manual.
It seems "--enable-manual" is included in the default options. For my build via "./configure --with-libssh2=/home/qxu/opensrc/libssh2-1.2 -disable-shared", "./curl --manual" works.
Now I can get the new -Q options:
(FTP/SFTP) Send an arbitrary command to the remote FTP or SFTP
server. Quote commands are sent BEFORE the transfer takes place
(just after the initial PWD command in an FTP transfer, to be
exact). To make commands take place after a successful transfer,
prefix them with a dash '-'. To make commands be sent after
libcurl has changed the working directory, just before the
transfer command(s), prefix the command with a '+' (this is only
supported for FTP). You may specify any number of commands. If
the server returns failure for one of the commands, the entire
operation will be aborted. You must send syntactically correct
FTP commands as RFC959 defines to FTP servers, or one of the
commands listed below to SFTP servers. This option can be used
SFTP is a binary protocol. Unlike for FTP, libcurl interprets
SFTP quote commands before sending them to the server. Follow-
ing is the list of all supported SFTP quote commands:
chgrp group file
The chgrp command sets the group ID of the file named by
the file operand to the group ID specified by the group
operand. The group operand is a decimal integer group ID.
chmod mode file
The chmod command modifies the file mode bits of the
specified file. The mode operand is an octal integer mode
chown user file
The chown command sets the owner of the file named by the
file operand to the user ID specified by the user
operand. The user operand is a decimal integer user ID.
ln source_file target_file
The ln and symlink commands create a symbolic link at the
target_file location pointing to the source_file loca-
The mkdir command creates the directory named by the
pwd The pwd command returns the absolute pathname of the cur-
rent working directory.
rename source target
The rename command renames the file or directory named by
the source operand to the destination path named by the
The rm command removes the file specified by the file
The rmdir command removes the directory entry specified
by the directory operand, provided it is empty.
symlink source_file target_file
There is a lot of difference from the old manual, regarding this option.
Thanks a lot,
List admin: http://cool.haxx.se/list/listinfo/curl-library
Received on 2009-10-19